Saturday 19 April 2014

The Physics Behind Parametric Rolling

Parametric Rolling is a problem related to hullforms that experience considerable change in submerged volume when a wave passes longitudinally along the ship. This is significantly seen mostly in hulls having large bow and stern flares, stern overhang, and fine underwater hull form, that is mostly in container ships, fishing vessels and in some cases, passanger ships too. The same problem was not encountered in full form hulls like oil tankers and bulk carriers. Why? 

In fine form hullforms with large flares and overhangs, the profile of waterlines when the ship experiences head seas changes rapidly as shown below:


Dotted Line: Waterline in still water
Continuous Line: Waterline when wave troughs at midships


Dotted Line: Waterline in still water
Continuous Line: Waterline when wave crest at midships

If you compare the figures above, you'll note that

  • When wave trough is at midships, the water plane width is more than that in case of still water, resulting in increased stability (GM) than still water condition.
  • When wave crest is  at midships, the water plane width is less than that in case of still water, making the stability (GM) less than that of still water condition.
This results in periodical increase and decrease in metacentric height of the ship. In one complete passage of a wave along the ship's length the GM increases and decreases once; that is, stability variation occurs twice in once wave period.

How a parametric roll devolops due to this phenomenon, is a very interesting case to study. When a container ship is facing head seas and slight roll motions,

  • In the first quarter (T = 0 to T = 0.25), when the midship experiences a wave trough, the GM increases (obviously, periodically varying according to the wave profile). So the roll angle decreases (initial roll degree was present due to small rolling motions in the ship). Had the ship been in still water, its roll angle at the end of the first quarter would have been zero. But a higher righting lever now actually causes the ship to end up with a slight roll angle to the other side! (just concentrate in the first quarter in the figure below)





  • Curse inertia, because of which the ship begins its roll to the other side. Don't forget, you've entered the second quarter (T=0.25 to T=0.50) i.e the midship now experiencing a wave crest. You're right! Decreased stability. And that means reduced righting lever compared to still water condition. By the end of this quarter, your ship's roll angle to the other side is more than what it would have been in still water. (refer to the second quarter in the above diagram)
In short, your ship is in trouble, as this phenomenon will only keep increasing untill it achieves a resonating condition. Goodbye to containers on the deck!


A container ship after experiencing parametric roll


Watch this video of a simulated parametric roll during a tank test:




PREVENTION and REDUCTION IN PARAMTERIC ROLLING:


  • Having Bilge Keels to damp roll motions





  • Having Antirolling Tanks (often U- Type passive antiroll tanks are preferred)




  • Stabilizer Fins (used in cruises and liners)



  • Well designed and properly checked container lashings




  • Course change from head or following seas to oblique heading when wave periods and heights can cause parametric roll motions. LSD




Article By: Soumya Chakraborty

Author's Note: This one was written to throw light upon the physical phenomena behind parametric rolls. Students in initial undergraduate level find it initially tough to understand the reason behind this action. This article was written in simple and interactive terms to help students get along with the physics behind parametric rolls. Case studies and numerical models of parametric rolling and dampening methods have been done by maritime organizations and researchers. So there was no point including them here. Images and videos used in the article donot belong to LSD and full credit goes to their respective owners. Thank You for reading. In case of any doubts and queries please comment or write to learnshipdesign@gmail.com

2 comments: